Access/Series M by Draper
Page 2 of 2
(Continued from Page 1)
Install the retaining clip on the spear, locking spear and bracket together.
While supporting the idler end of the roller, slide the idler end mounting
bracket toward the roller. Insert the roller pin into the nylon bushing on the
idler end mounting bracket.
The roller idler pin needs to go through the idler bracket far enough to allow
the washer and retaining clip to be reinstalled on the pin. Failure to replace
the washer and retaining clip as shown could result in the separation of the
roller from the brackets.
Securely tighten the four set screws on the idler end mounting bracket.
Reinstall the bottom access panel as previously described.
Spring Roller/Fabric Removal
Reverse the instructions above “Spring Roller/Fabric Installation” for removal
of the unit.
Mounting hardware supplied by others
Engagement bracket (one on each end
of the bottom access panel) clicks into
place with the ball detent on each endcap.
1
5
/32"
4
23
/
32
"
2
1
/
8
"
Retaining
clip
Roller pin
Retaining clip
Washer
Nylon bushing
Roller mtg. brkt.
Roller
A
B
C
A
B
Standard Roller
AutoReturn Roller
Roller Hole
Dia. Position
1¾" A
2¼" B
3" C
www.draperinc.com
(765) 987-799
3
/8"
1
3
/8"
1
/8"
1
/2"
R
1
/4"
1
/4"
R
1
/8"
5
/16"
4
1
/2"
3
/16"
5
/16"
3
/16"
1
1
/8"
1
/4"
1
1
/4"
4
13
/16"
9"
7
3
/4"
1
1
/2"
Mounting Bracket Dimensions
3"
Mounting brackets slide
left and right as needed.
9"
8"
7"
6
5
/8"
2
1
/8"
slot
11
/16"
1"
11
/16"
6
5
/8"
Case Dimensions
Operating Instructions—Standard
To lower picture surface, pull screen down. Hesitate—then allow screen to
retract very slowly until it locks in place.
To raise picture surface, pull screen down and, while holding, allow for slow
retraction into the case to reduce risk of injury from falling screen.
Operating Instructions—AutoReturn
To lower picture surface, pull screen down. Hesitate—then allow screen to
retract very slowly until it locks in place.
To raise picture surface, pull screen down gently until it stops, then release.
Viewing Surface Care & Maintenance
Matt White & High Contrast Grey
Clean surface with a solution of mild dishwashing liquid diluted with warm
water. Sponge the surface, rinse with clear water and blot dry. Do not use
clean ing solvents or abrasives.
Glass Beaded
Clean with a very soft brush or cloth and care ful ly dust the surface. DO
NOT USE SOAP, WATER, SOLVENTS OR ABRASIVES. These substances
will damage a glass beaded viewing surface.
(1 strony)
(2 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji